How Brass Wire Grades Are Organized
Brass wire grades are identified by their nominal copper content. Under the Chinese designation system, H96 means approximately 96 percent copper, H90 means 90 percent, and so on down to H59 at about 59 percent. As the zinc content rises, the wire becomes stronger and cheaper but loses corrosion resistance and ductility. The same grades are known internationally under UNS numbers, with H96 equivalent to C21000, H90 to C22000, H85 to C23000, H70 to C26000, H68 to C26800 and H65 to C27000.
High-Copper Grades: H96 and H90
H96 contains about 96 percent copper and 4 percent zinc. It has excellent cold and hot workability, easy weldability and solderability, high corrosion resistance in atmospheric and fresh-water service, and no tendency to stress-corrosion cracking. It is used for currency blanks, commemorative items, badges, detonators, cartridge cases, enamel bases, waveguides and heat-dissipation components. H90, with 90 percent copper and 10 percent zinc, adds a little strength while keeping excellent working characteristics, and suits medals, ship fittings, rivets, waveguides, battery caps, water pipe and bimetallic strips.
Mid-Range Grades: H85 and H70
H85 balances mechanical properties with corrosion resistance, offers excellent cold workability and good hot formability, and is used for architectural decoration, badges, bellows, serpentine tubes, water pipes, condenser and heat exchanger tubes. H70 is the classic 70/30 cartridge brass, with high plasticity and strength, good cold forming, easy welding and good corrosion resistance. It is used for signs, musical instruments, flexible hoses, pump pipes, bellows and building supplies. Note that H70 is sensitive to stress-corrosion cracking in ammonia atmospheres and should be stress-relieved after forming.
Workhorse Grades: H68, H65, H63 and H62
H68 offers good plasticity, high strength and excellent machinability, and is widely used for fasteners, springs, terminals and decorative parts. H65 and H63 provide intermediate balances for drawn and bent components, while H62, equivalent to C28000, is the economical workhorse for fasteners, radiator parts and plumbing fittings where its higher strength offsets its lower ductility.
Choosing the Right Brass Wire
For electrical and thermal duty, choose high-copper grades H96 or H90. For deep drawing and forming, choose H70 or H68. For machined fasteners and hardware at controlled cost, H65, H63 or H62 are the practical options. Always confirm the required temper and diameter, because wire properties change significantly with cold work and annealing.
Frequently Asked Questions
Q: What does the number in H96 or H62 mean?
A: It indicates the nominal copper percentage of the brass grade.
Q: Which brass wire grade has the best conductivity?
A: H96, with the highest copper content and therefore the highest conductivity.
Q: Which grade is best for deep drawing?
A: H70 or H68, whose alpha-phase structure gives the highest ductility.
Q: Is H62 brass wire corrosion-resistant?
A: Adequately in atmospheric and fresh-water service; it is not suitable for marine or acidic environments.
Q: What is the UNS equivalent of H70?
A: C26000, cartridge brass.
Q: How is brass wire supplied?
A: In coils or spools, in diameters from under 0.1 mm to about 12 mm, in soft, half-hard, hard and spring tempers.




