Mar 18, 2025 Leave a message

C95400 Copper Alloy: Composition, Properties and Applications

Introduction

This article provides an in-depth look at the C95400 copper alloy. C95400 is a cast aluminum bronze with a nominal composition of 83 to 87 percent copper, 10.0 to 11.5 percent aluminum and 3.0 to 5.0 percent iron. It is the most widely used aluminum bronze casting alloy, combining high strength with excellent corrosion and wear resistance.

Composition

The alloy is defined by its aluminum and iron content, with the balance copper and small limits on nickel, zinc and other impurities. The iron refines the structure and strengthens the casting, and the aluminum provides the corrosion-resistant passive film that protects the material in seawater and chemical service.

Properties

C95400 reaches tensile strengths of about 515 to 655 MPa in the heat-treated condition with yield strengths above 250 MPa and hardness in the range of 190 to 210 HB. It resists wear, galling and corrosion in marine and industrial environments, and it can be machined to close tolerances.

Property Typical Value
Copper 83 - 87%
Aluminum 10.0 - 11.5%
Iron 3.0 - 5.0%
Tensile strength 515 - 655 MPa

Applications

Typical castings are heavy-duty bearings and bushings, gears, worm wheels, valve seats and bodies, pump impellers, marine hardware, and wear plates. The material is covered by ASTM B148, with the equivalent alloy C95410 and similar grades in other national standards.

Selection and Verification

Confirm the casting process, heat treatment and mechanical test results on the certificate, and verify the chemical analysis against the standard. For loaded bearings, check the hardness and the machining allowance with the foundry.

FAQ

1. What is C95400? A cast aluminum bronze with about 10 to 11.5 percent aluminum and 3 to 5 percent iron.
2. What strength does it reach? Tensile strengths of about 515 to 655 MPa in the heat-treated condition.
3. Where is it used? Bearings, bushings, gears, valve components, pump impellers and marine hardware.
4. What standard covers it? ASTM B148 for copper alloy castings.
5. Can it be welded? Yes, with matching aluminum bronze filler metal and controlled preheat.
6. Why add iron? Iron refines the casting structure and increases strength and wear resistance.

Send Inquiry

whatsapp

Phone

E-mail

Inquiry